openUTM-LU62 Gateway error messages during administration

	When administering the openUTM-LU62 Gateway in the Management Console (activating/deactivating traces) the openUTM-LU62 u62_adm utility outputs messages to stdout. All these messages begin with the prefix u62_adm <nn>, where <nn> specifies the message number. Messages with the following numbers indicate normal behavior: 20 to 45, 56 For messages with the numbers 06, 09, 12, 13, 52, 53 and 59 see below. For all the other u62_adm <nn> messages that are not listed above, inform system service.
06	Instance &INST: Instance is still initializing or terminating. The proxy component openUTM-LU62 Gateway is currently being started or terminated. Action: Repeat the action.
09	Instance &INST: Instance does not respond in time. Delay which can occur with high load and in large configurations. Action: Repeat the action.
12	No openUTM-LU62 instance active. The proxy component openUTM-LU62 Gateway has not been started yet. Action: Start the openUTM-LU62 Gateway.
13	The given instance is not active. The proxy component openUTM-LU62 Gateway has not been started yet. Action: Start the openUTM-LU62 Gateway.
52	Error opening the trace file &FILENAME, errno &ERRNO (&ERRTXT) Action: For ERRNO see  System error codes  or inform system service.
53	Error reading from trace file &FILENAME, errno &ERRNO (&ERRTXT) The specified file is not a trace file of the openUTM-LU62 Gateway. Action: Specify the correct file.
59	Extracting the protocol trace may take some time. Please wait ... Action: Wait for trace extraction to be completed.