RESUME-TASK

Release suspended batch task

Component:	BS2000
Functional area:	Job processing
Domain:	SYSTEM-TUNING
Privileges:	TSOS OPERATING
Routing code:	J

Function

A batch task previously placed on hold with the HOLD-TASK command is released with RESUME-TASK.
Only after this release can the job be canceled, if required, with the CANCEL-JOB command. In the case of a task which is waiting for an operator response, if a RESUME-TASK command is issued after a HOLD-TASK command, the following message will appear:

EXC0712 TASK NOT PENDED BY HOLD-TASK COMMAND. /RESUME-TASK REJECTED

Not until the operator response is entered will the task be put on hold. A second RESUME-TASK command will be required to cancel the hold state for the task.

Format

RESUME-TASK                                                                                                                                            

JOB-IDENTIFICATION = *TSN (...) / *MONJV(...)
	*TSN(...)
		|		TSN = <alphanum-name 1..4>
	*MONJV(...)
		|		MONJV = <filename 1..54 without-gen-ver>

Operands

JOB-IDENTIFICATION =
The batch job for which the wait state is to be canceled can be identified either by its task sequence number (TSN) or by a declared monitoring job variable (MONJV).

JOB-IDENTIFICATION = *TSN(...)
Preset value: the job is identified by its TSN.

TSN = <alphanum-name 1..4>
TSN of the batch job to be resumed.

JOB-IDENTIFICATION = *MONJV(...)
Preset value: the job is identified by its monitoring job variable.

MONJV = <filename 1..54 without-gen-ver>
Specifies the monitoring job variable of the batch task for which the wait state is to be canceled.

Return codes

(SC2)	SC1	Maincode	Meaning
	0	CMD0001	No error
12	64	EXC0711	Specified task sequence number (TSN) not found
12	64	EXC0712	Task is not on hold
12	64	EXC0715	Command is not allowed for this task type