DELETE-SW-CONF - Delete software configuration

An existing software configuration is deleted.

Format

DELETE-SW-CONF                                                                                                                                       

NAME = 'swkonfname'

[,PASS = 'password']

[,ERROR = ON(<integer 0..31>) / OFF(<integer 0..31>)]

Operands

NAME = 'swkonfname'
Name of an existing software configuration that is to be deleted.

PASS = 'password'
Password with which the software configuration is protected. If the software configuration is protected with a password, this must be entered before the software configuration can be deleted.

ERROR = ON(<integer 0..31>) / OFF(<integer 0..31>)
In the event of an error, the specified job switch is set (ON) or reset (OFF).