Starting EDT

In compatibility mode, EDT is loaded and started with the command /START-EDT. The /START-EDT command corresponds to the command in EDT V16.6B. For a description, see the manual “EDT V16.6B Statements” [2].

For reasons of compatibility, it is still possible to call EDT using /START-PROGRAM. EDT is then loaded as a main program with one of the following BS2000 commands and is started in compatibility mode:

Command	AMODE
START-PROGRAM $.EDT	AMODE 31
START-PROGRAM *MODULE ($.SYSLNK.EDT.170, EDTC, RUN-MODE=*ADVANCED)	AMODE 24