To allow ADM traps from your openFT instance on the BS2000 system to be sent to the ADM trap server, you must carry out the following actions in your role as FT administrator:
Enter the address and admission data for the ADM trap server
Specify the scope of the ADM traps sent to the ADM trap server
In addition, the FT administrator of the ADM trap server must set up a corresponding admission profile on the ADM trap server.
Enter the address and admission data for the ADM trap server
You specify the address and the transfer admission of the ADM trap server in the ADM- TRAPS operand of the MODIFY-FT-OPTIONS command:
|
adm-trap-server
must be defined in the partner list using the address format ftadm://host... . Alternatively, you can also enter the address directly in the format ftadm://host...
trap-admission
is the transfer admission for the admission profile defined in the ADM trap server for this purpose.
Specify the scope of the ADM traps
The scope of the ADM traps sent to the ADM trap server is controlled using the operating parameters. You can set which of the events listed below cause traps to be sent:
Change of openFT status ( START-FT / STOP-FT )
Change of partner status
Unavailability of partners
Change of request management status
Successfully completed requests
Failed requests
To do this, use the MODIFY-FT-OPTIONS command and defying the required selection under SELECTION in the ADM-TRAPS operand.