The procedure OPFTTEMP.OP121an.F1 can be used to perform the installation.
The openFT-FTP delivery unit can only be installed if the local openFT instance has been fully shut down. You should therefore proceed as follows to perform installation:
Shut down openFT using the FTSTOP command.
Use the FTTERM command to terminate the started openFT job or terminate the started openFT task.
The following steps are necessary in order to install openFT-FTP:
Specify the required installation directory or installation prefix by setting the T_BASE variable in the procedure OPFTTEMP.OP121an.F1.
The default settings are the user ID and directory in which the temporary installation files are located.
Call the following procedures to install openFT-FTP:
EXEC 'USERID.OPFTTEMP.OP121an.F1(OPFTP#1)' EXEC 'USERID.OPFTTEMP.OP121an.F1(OPFTP#2)' EXEC 'USERID.OPFTTEMP.OP121an.F1(OPFTP#3)' EXEC 'USERID.OPFTTEMP.OP121an.F1(OPFTP#4)' EXEC 'USERID.OPFTTEMP.OP121an.F1(OPFTP#5)'
The OPENFTP load module contained in the library OPENFT.OP121an.F3 is installed under the same name as a member of the same library that contains the load modules for openFT.
In order to use the FTP functionality, proceed as follows after the installation:
Restart the local openFT instance, i.e. load the openFT job using the FJINIT command or restart openFT as a "started task".
Then activate openFT with FTSTART.
//OPENFT EXEC PGM=OPENFT,TIME=1440,
must be changed to
//OPENFT EXEC PGM=OPENFTSL,TIME=1440,
See also example in section “openFT as a job or started task”.