You can start the follow-up processing under one of the job classes which you have selected by adding the following command in the follow-up processing:
/REMARK %JOBCLASS=<jobclass>
The following conditions apply for the metastring %JOBCLASS=<jobclass>
no blanks are permitted within the metastring,
the metastring must be located immediately before a semicolon (command separator) or at the end of a command sequence,
the metastring must be after a REMARK or something similar, since it is not deleted before the follow-up processing is performed and otherwise will be mistaken for an invalid follow-up processing command.
openFT checks if the job class is available for the user. If it is, then it is used for the followup processing. If it isn’t, then the default job class or JBCLJOB is used.
If no direct or indirect (e.g. default) specification is made in the command for a variable which occurs in the follow-up processing data, then it is removed from the follow-up processing data and not replaced.