BCAM permits manual intervention in a configuration using a number of MODIFY commands. Manual interventions in a configuration must be implemented with care.
Modifications can be made for
options
AEC options
DNS settings
parameters
timers
server ports
ADDRESS-ASSIGNMENT entries for routers (mainly for IPv4)
VLAN-ASSIGNMENT entries for VLAN assignment
virtual hosts
lines
VLAN lines
VLAN devices
processors and routes
The following MODIFY commands are available to modify individual objects, settings, parameters and timers:
MODIFY command | Meaning |
BCGEN | Assign a new BCAM name or a new partner address for a processor. This also applies for multiple routes with the same partner address. |
BCMOD | Modify BCAM parameters, supported by SHOW-BCAM-PARAMETER ,OUT-F=*GEN |
BCOPTION (AEC-OPTIONS) | Modify AEC-OPTIONS, supported by SHOW-AEC-OPTIONS ,OUT-F=*GEN |
BCOPTION (ADDRESS-RANGE) | Modify ADDRESS-RANGE settings, supported by SHOW-ADDRESS-RANGE ,OUT-F=*GEN |
BCOPTION (SERVER-PORTS) | Modify SERVER-PORTS settings, supported by SHOW-SERVER-PORTS ...,OUT-F=*GEN |
BCTIMES | Modify timer settings, supported by SHOW-BCAM-TIMER ,OUT-F=*GEN |
MODIFY-ADDRESS-ASSIGNMENT | Specify address assignment to routers, supported by SHOW-ADDRESS-ASS ...,OUT-F=*GEN |
MODIFY-BCAM-OPTIONS | Modify BCAM options, supported by SHOW-BCAM-OPTIONS ,OUT-F=*GEN |
MODIFY-DNS-ACCESS | Define DNS restrictions in BCAM and addressing of the standard DNS Resolver daemon, supported by SHOW-DNS-ACCESS ...,OUT-F=*GEN |
MODIFY-HOST-ATTRIBUTES | Modify settings for hosts |
MODIFY-LINE | Modify settings for lines |
MODIFY-OWN-ADDRESS | Reassign addresses to a different line in redundant configurations |
MODIFY-ROUTE-ATTRIBUTES | Modify route attributes |
MODIFY-ROUTE-PATH | Reassign routes (see the section "Modifying route configuration") |
MODIFY-VLAN-ASSIGNMENT | Specify address assignment to a VLAN, supported by SHOW-VLAN-ASS ...,OUT-F=*GEN |
MODIFY-VLAN-DEVICE | Modify settings for VLAN devices |
MODIFY-VLAN-LINE | Modify settings for VLAN lines |
MODIFY commands for modifying individual objects
Note
You can also generate the individual commands separately by issuing the corresponding SHOW commands with the OUTPUT-FORMAT=*GENERATING-CMD parameter.