With the PREP-BCAM-INFO-MSG command you can filter the output of notification based BCAM-SHOW commands for a specific string. The output is adjusted according to the notification inserts and is therefore easy to read.
Only the notifications that contain the specified string are displayed.
PREP-BCAM-INFO-MSG can only be used in dialogue and is used for diagnostics.
The alias name for PREP-BCAM-INFO-MSG is PPBCIM.
BS2000 console | BS2000-SDF command | Command/SOF file | SNMP management | Parameter service |
x |
List of valid command sources
PREP-BCAM-INFO-MSG / PPBCIM |
CMD=<text 0..1800 case sensitive> / <c-string 0..1800> ,SEARCH = *NONE / <text 0..1800 case sensitive> ,OUTPUT = *SYSOUT / <filename_1..54> |
CMD=<text 0..1800 case sensitive> / <c-string 0..1800>
specifies the command, in whose output a string should be searched.
OUTPUT=...
Specifies the output medium.
OUTPUT=*SYSOUT
The output is sent to SYSOUT.
OUTPUT=<filename_1..54>
Output takes place to a file with the specified name. The specified file is overwritten, if it already exists.
SEARCH=...
specifies the search string that is to be searched for in the output information.
SEARCH=*NONE
There is no search string specified, i.e. the complete command output is shown in prepared SYSOUT format.
SEARCH=<text 0..1800 case sensitive>
String to be searched for. Only the notifications that contain the specified string are prepared and displayed.
Command logging
Usually, an output is created for the requested information.
For the description of the possible error messages during command processing, please see the following table.
Command return codes
(SC2) | Maincode | Bedeutung |
| CMD0001 | No error |
| CMD0202 | Syntax error |
Note
Due to procedural command processing, there are no detailed command return codes. An output will always be created, unless a syntax error was found in the command.
Example
Output of the prepared connectivity information:
/PREP-BCAM-INFO-MSG CMD=SHOW-CONN,SEARCH=MCH