SHOW-BCAM-INFO-CONFIG / SHBCIC: Show BCAM configuration information

You use the SHOW-BCAM-INFO-CONFIG command to show BCAM configuration information. This command can only be specified in interactive mode and is based on existing BCAM-SHOW functions. The command is used for diagnostic purposes.

The alias name for SHOW-BCAM-INFO-CONFIG is SHBCIC.

BS2000 console	BS2000 SDF command	Command/SOF file	SNMP management	Parameter service
	x

List of valid command sources

SHOW-BCAM-INFO-CONFIG / SHBCIC                                                                                     

Command logging

In the normal case the required information is output.
A description of the error messages that can be issued during command processing is provided in the table below

Command return codes

(SC2)      SC1	Maincode	Bedeutung
0        0	CMD0001	Command successfully processed
0        1	CMD0202	Syntax error

Note

More detailed command return codes are not provided owing to the procedural processing of the command. An output always takes place unless a syntax error was detected in the command.

Example

Show the BCAM configuration information:

/SHOW-BCAM-INFO-CONFIG