Your Browser is not longer supported

Please use Google Chrome, Mozilla Firefox or Microsoft Edge to view the page correctly
Loading...

{{viewport.spaceProperty.prod}}

BCIN: Initialize line

&pagelevel(5)&pagelevel

BCIN on a line

LINE = <line-name 1 .. 8>

,ACT = YES / NO

,SLOW-POLL = *std / OFF / ON

,CONFIGURATION = UPDATE / PRIMARY / NO

LINE=<line-name 1..8>
Name of the line

ACT=...
Specifies which objects are to be activated.

ACT=YES
The line is activated.

ACT=NO
The line is not activated.

SLOW-POLL=...
Defines the SLOW-POLL behavior for lines to LAN nodes. SLOW-POLL is only set if the affected connection is not active.

SLOW-POLL= *std
The general SLOW-POLL default setting (MODIFY-BCAM-OPTION command) is used.

SLOW-POLL=OFF
No reactivation following a line failure.

SLOW-POLL=ON
Causes automatic reactivation following a line failure. This reactivation is attempted every 15 seconds until it succeeds or until a BCDAC or BCOUT command is issued.

CONFIGURATION=...
The operand specifies whether or not IP, IPv6 and INTF routes which are assigned to the line to be activated can be assigned to an alternative line if the one to be activated fails, for example, or on activating the line for the first time.

CONFIGURATION=UPDATE
IP, IPv6 and INTF routes may be assigned to an alternative line.

CONFIGURATION=PRIMARY
IP, IPv6 and INTF routes are assigned to the line to be activated on activating the line.If the line to be activated fails, the IP, IPv6 and INTF routes may be reassigned to an alternative line.
In contrast to UPDATE, the routes are switched back to the specified line when that line becomes active again.

CONFIGURATION=NO
IP, IPv6 and INTF routes are always assigned to the line to be activated.
If the line to be activated fails, no alternative line is assigned for IP and INTF routes.

Command logging

For reasons of compatibility, positive acknowledgments are supplied in news BCA0763, and negative acknowledgments in news BCA0762, followed by the message NBR0740. In addition, for positive acknowledgments, the messages BCA083F and BCA0620 may also appear.
A description of the error messages that may be issued during command processing is provided in the table below.

Command return codes

(SC2)      SC1

Maincode

Meaning

   0        0

CMD0001

Command successfully processed

   2        0

BCA0621

Startup aborted

   2        0

BCA0777

DMS-GETKY interface used for RDF

   0        1

BCA0768

Syntax error in command

   0       64

BCA08E5

Object is unknown

   0       64

BCA0998

Configuration error in device ... of the line ...

   0      128

BCA0814

BCAM is being terminated abnormally

   0      128

BCA0816

BCAM is terminating

   0      130

BCA0766

BCAM is not active