You use the SHOW-BCAM-INFO-NAME command to show information on BCAM objects which are selected by means of a name. This command can only be specified in interactive mode and is based on existing BCAM-SHOW functions. The command is used for diagnostic purposes.
The alias name for SHOW-BCAM-INFO-NAME is SHBCIN.
BS2000 console | BS2000 SDF command | Command/SOF file | SNMP management | Parameter service |
x |
List of valid command sources
SHOW-BCAM-INFO-NAME / SHBCIN |
NAME = *OWN / <text 1..256> |
NAME=...
In NAME you specify a BCAM or DNS name for which information is to be shown.
NAME=*OWN
Specifies the BCAM name of the processor from which the current interactive connection was established.
NAME=<text 1..256>
Specifies the BCAM name or the DNS name.
Command logging
In the normal case the required information is output.
A description of the error messages that can be issued during command processing is provided in the table below
Command return codes
(SC2) | Maincode | Bedeutung |
| CMD0001 | Command successfully processed |
| CMD0202 | Syntax error |
Note
More detailed command return codes are not provided owing to the procedural processing of the command. An output always takes place unless a syntax error was detected in the command.
Example
Show the information on a name:
/SHOW-BCAM-INFO-NAME mgphugo.mgp.example.net