Loading...
Select Version
&pagelevel(4)&pagelevel
It is possible to activate the BCAM traces and start the communication system during the start-up phase of the CLASS2-EXEC. To perform a BCAM start, you must specify the following parameters in the BS2000 parameter file:
/BS2000 PARAMS
.
.
/BEGIN BCAM
[/DCDIAG ....]
/DCSTART ...
/EOF
.
.
/END-PARAMS
The DCDIAG command should only be used for debugging purposes, as it impedes the system performance.
All the parameters of the DCDIAG command can be used.
For system-related reasons, implementation of the DCSTART command is subject to restrictions. The parameters that cannot be used are described in section "DCOPT: Predefine DCSTART parameters" and in section "DCSTART: Start the data communication system in BS2000".