SHOW-SELECTED-HOSTS Output selected hosts

This statement is used to output the hosts selected with the SELECT-HOSTS statement. The display includes the host name, the processor name (from the point of view of the host from which the statement was issued), and the time of the last monitored data queried.

If there is no valid or new data, RSLT NOT VALID is output instead of the time. Possible reasons for this are listed below:

• Monitored data was not queried since the SELECT-HOSTS statement.

• The remote host is not sending.

• The remote host shows a different system time or uses a different SM2 monitoring cycle. Data from the respective hosts (including the local host) is output separately.

Format

SHOW-SELECTED-HOSTS