KDCSEND allows you to send messages to one, several or all active terminals of a UTM application on BS2000 systems. openUTM then sends message K023 with the specified messages as an insert. This is output by default in the system line on the terminal. However, the message destination of message K023 can be changed. If the message destination PARTNER is selected for the UTM message K023, you can send the message to one, several or all connected TS applications. The message goes only go to dialog partners (LTERM with USAGE=D).
|
|
For administration using message queuing you must enter KDCSENDA.
MSG='message' | ||
For message, enter the message to be sent. It should be enclosed in single quotes and must not be longer than 74 characters. Write double quotes within the message text (i.e. do not use single inverted commas as part of your message text). | ||
LTERM= | Specifies the LTERM partner to which the message should be sent. | |
(ltermname_1,...,ltermname_10) | ||
Name of the LTERM partner to which the message is to be sent. You can enter a total of up to 10 names. If you only enter one name, you do not need to key in the parentheses. | ||
KDCALL | ||
This message should be sent to all active LTERM partners, i.e. to all clients connected by a logical connection at the present time. Default: KDCALL | ||
Output from KDCSEND
The message message is displayed on the administrator terminal.