The PERCON run can be interrupted as follows:
interactive mode: by means of the interrupt key at the terminal (K2 key) and by entering the command /INFORM-PROGRAM
in ENTER mode by entering /INFORM-PROGRAM from the console.
After the /INFORM-PROGRAM command has been entered, the message PER0070 is output. Further execution is controlled by entering one of the following operation codes in response.
Operation code | Meaning |
DISP | The current processing status is output (record/block counter). |
CONT | Processing is continued. |
START | The current conversion step is aborted and the next conversion step started. |
FIN | Reading from the current input file is terminated and continued from the |
TERM | The PERCON run is terminated. |
If DISP is entered, the same message issued after the /INFORM-PROGRAM command is also output after the information on the current processing status. Further execution again depends on the subsequent entry of an operation code.
Note
The entries DISP, CONT, START, FIN and TERM must not be abbreviated.