All BS2000 systems which are to participate in ROBAR operation require a connection to ROBAR-SV on the ROBAR server.
You can implement the physical connection from the BS2000 system to the ROBAR server via LAN (TCP/IP protocol).
You make the names and the connection-specific parameters known via the Transport Name Service of the CMX on the ROBAR server (see section "Generation of names for CMX").
Figure 18: Connection of ROBAR-CL and ROBAR-SV
When ROBAR-CL and the ROBAR server are located on systems of the same SE server, it is recommended that the SE server's MCNPR network be used for the connection. The SENET host name of the relevant BS2000 host should be entered in the CMX configuration as the IP address.
When ROBAR-CL on a system of the SE server is to be connected to an external ROBAR server, it is recommended that the connection be established over the SE server's MANPU network.