CRD functionality; CRD with external configuration disks

Central data of the SE Server configuration is stored on a so-called configuration disk of a unit (MU, SU x86, HNC):

• General data of the SE Server:
  • Model, name and location
  • Unit-overarching data
• Unit-specific data the content of which must be available also after an outage or after the unit (MU/SU /390, SU x86) has been turned off:
  • Model, SW version and hostname
  • IP configuration
  • FC configuration
  • VM data for BS2000 (on SU x86 also for  XenVMs (Linux and Windows))
  • Storage of the last CSR backup
• Current configuration of the Net Unit switches

By default the above mentioned data are written locally on an internally mirrored disk of the MU/SU/HNC – the internal configuration disk.

CRD with external configuration disks

Additionally to the internal configuration disk, up to two external configuration disks can be configured situated on external FC RAID systems to which all MU and SU x86 have access through a redundant connection.  

The internal and the external configuration disks are combined to a logical unit („logical disk“) via mirroring in SW-technical way and built up to the so-called "CRD" ("Configuration Raw Device") which provides the “CRD functionality” to all MU and SU x86.

The above mentioned central data of the SE Server configuration are „written on the CRD“ and read from there.

With the CRD functionality every MU and SU x86 has the same view on the data of the SE Server and the actions on these units can be done in coordinated way. (unit-overarching consistence)  

Example with CRD principle:

External configuration disks (also called CRD disks) are required in the following cases: 

MU redundancy for SE700/SE500	-> mandatory The external configuration disks must be configured on both MUs.
MU redundancy for SE300	-> recommended The absence leads to some restrictions (see “Administration and Operation“ for FUJITSU Server BS2000 SE700 / SE500 / SE300 [1]) The external configuration disks must be configured on both MUs.
Cluster	-> mandatory for every type of cluster Management Cluster: The external configuration disks must be configured on all MUs. SU /390 Cluster: The external configuration disks must be configured on all MUs. SU x86 Cluster: The external configuration disks must be configured on the participating SU x86.

Technically, it is external disks with FC connection and a capacity of at least 8 GB that have to be used for external configuration disks.
The MU and the SU x86 access the external configuration disks directly through FC. SU /390 access the external configuration through the BS2000 subsystem REWAS and one MU (in normal operation through a server-local MU).

Recommandations and notes

• To avoid a „single point of failure" a configuration with two external configuration disks in different storage systems with redundant FC connections is recommended.
• Every external configuration disk must be accessible from every MU (X-cabling or SAN-X-configuration of the RAID periphery).
• In case of a SU x86 cluster the external configuration disks must be also accessible from every SU x86.
• A maximal distance of 15 km between the locations is recommended.
• Note:
  The cluster software does not check whether the above conditions are met. This has to be ensured by the customer through a suitable configuration of the infrastructure.

The configuration disks are provided by the customer and are set up by the customer’s service.
The unit specific configuration disks and their current status are displayed under
  Hardware -> Units (SE<model>) -> <unit> (MU) -> Information tab Configuration disks in the SE Manager.
Their current status is displayed in the main window of the cluster for which it is relevant.