AU25s require 1 or 2 height units in the rack. AU25s are set up on the same system unit as the PRIMERGY servers RX2530/RX2540 M<x>. Differences in the basic units exist to permit integration of the Application Units into the SE server and to enhance the SE server’s redundancy features.
In the event of questions, e.g. regarding application compatibility, the information for the PRIMERGY servers RX2530/RX2540 M<x> also applies for the Application Units of the SE server.
Security functions in the BIOS setup and on the system board protect the data against manipulation. Information on the security functions is provided in the manual "BIOS Setup Utility for FUJITSU Server PRIMERGY RX25yy M<x>" on the Manual Server (http://manuals.ts.fujitsu.com):
> | Go to x86 Servers |
With the release of Service Pack 1 of SE V6.2A, AU25 M4 is also released after AU25 M1. With SE V6.3A, AU25 M4 on the basis of PRIMERGY RX2540 M4 is released as well as AU2540 M5 on the basis of PRIMERGY RX2540 M5.
Features
AU25s based on PRIMERGY RX2530 contain one or two Intel XEON processors, have a storage capacity of up to 1.5 TB and offer four PCI express slots.
AU25s based on PRIMERGY RX2540 contain one or two Intel XEON processors, have a storage capacity of up to 3 TB and offer - depending on the configuration - up to eight PCI express slots.
Detailed information on the various hardware components and interfaces of the Application Units is provided in the data sheet "FUJITSU Server BS2000 SE Series". See the product site for the relevant server at http://www.fujitsu.com/uk:
> | Go to Products |