Setting operating mode via PROGRAM LOAD FRAME: DETAIL-2

The operating mode can be set anew according to the setting using PROGRAM LOAD FRAME: DETAIL-2. This selects the appropriate firmware for running BS2000 or VM2000.

The following are specified in the example below:

• VM2000 operating mode

• executing IPL after reloading the firmware

Requirement

You are in the PROGRAM LOAD FRAME: DETAIL-1 screen.

Invoke the PROGRAM LOAD FRAME: DETAIL-2 screen

• Click on PF9

  The PROGRAM LOAD FRAME: DETAIL-2 screen is displayed:

                 ----- PROGRAM LOAD FRAME: DETAIL-2 -----     E90L01G
  
  
  -VM MODE-                             -IPL EXECUTION-
    ==> 2                                 ==> 1 
   >*1 NATIVE                            >*1 ENABLE 
    *2 AVM/EX                             *2 DISABLE 
  
  
  
  
  
  
  
  
                                             *ENTER EXECUTE 
                                             *PF3   GO TO BASIC FRAME 
                                             *PF9   GO TO DETAIL-1 
  
                 CL-0        CPU-0 CHP-0         RUN
  
  RA                                                       []-[]00

  Figure 33: PROGRAM LOAD FRAME: DETAIL-2 screen

  VM MODE ==>	Enter 2 for VM2000 operation
  IPL EXECUTION ==>	Enter 1 for executing IPL

Storing settings

• After you have checked all the settings, click on PF9 to store them and to switch to PROGRAM LOAD FRAME: DETAIL-1.

  The new setting is displayed under VM MODE: in the DETAIL-2 STATUS field. VM MODE: AVM/EX is now displayed. The firmware is relocated before the IPL is executed.

  By filling PROGRAM LOAD FRAME: DETAIL-1 and pressing ENTER you can execute the IPL (see "Executing IPL in PROGRAM LOAD FRAME: DETAIL-1").

  Make sure you fill in the PARMS field correctly.