Operating status

The following table informs on the operating status output of remote copy mode based on output of /SHOW-REMOTE-COPY-STATUS.

The operating status is indicated by the values of REM-COPY-STATE and TARGET-ACCESS (see table). The other fields indicate the device status.

Operating status	Output of /SHOW-REMOTE-COPY-STATUS
	REM-COPY-STATE column	TARGET-ACCESS column
OK	ACTIVE	BY-SRC
Failure of part of the remote copy pair	ERROR	NONE
Complete failure	ERROR / BROKEN	NONE
Failure after target units were released	IN-HOLD	DIRECT
Failure recovery (after /SWAP-REMOTE-COPY)	ERROR	UNKNOW
Failure recovery test	IN-HOLD	DIRECT

Example

/SHOW-REMOTE-COPY-STATUS UNIT=9A01 

 %  -----------------------------------------------------------------------------
 %  SRC   TAR   VOLUME!REMOTE-COPY  TARGET!LAST-STA-CHNG!LINK  !SYNC!SRC!CON!CAS 
 %  UNIT  UNIT        !STATE   MODE ACCESS!DDDD.HH:MM:SS!      !    !-RA!R-C!R-C 
 %  =============================================================================
 %   9A02  9C02 S351.2!IN-HOLD SYNC DIRECT!   0.06:13:48!AVAIL.! 90%! - !NO ! -