Configuring the openSM2 agent

The following section describes the activities required for putting the openSM2 agent into functional state. Without those steps openSM2 agent is useless and returns no-data(-1) state for most of the objects.

Prerequisites:

• SM2 subsystem is created.

• SM2 measurement is configured and enabled. This could be done by executing the following statements in BS2000:

  /START-SM2 
  *call-admin-part
  %//set-periodic-task-parameter log-tasks=*none
  %//start-measurement-program per
  %//start-measurement-program utm
  %//call-eval-part
  *end
  

If openUTM performance monitoring is expected, openSM2 monitoring has to be activated for the respective UTM applications, e.g. by using the UTM administration command KDCAPPL SM2=ON.