Starting UDS-D operation (&START DISTRIBUTION)

For UDS-D

&START DISTRIBUTION          

This command is used to start UDS-D operation, i.e. to start the UDS-D task UDSCT, when

• the DBH has been started with the DBH load parameter PP
  DISTRIBUTION=STANDBY

• the DBH has been started with the DBH load parameter PP DISTRIBUTION=START, but UDS-D operation has since been terminated with the DAL command &CLOSE DISTRIBUTION

• UDS-D operation has been abnormally terminated (see section “Restarting UDS-D mode”).

Once UDS-D operation has been started, distributed transactions are possible.