You must install openUTM before installing BeanConnect.
Open the DOS command prompt with administrative permissions and enter the following command:
msiexec /i <openutm-directory>\utm-32.msi resp. utm-64.msi (32/64 bit mode)
Follow the installation program instructions and select the appropriate options.
openUTM checks the system requirements and makes sure that sufficient disk space is available. If the system fails to meet the requirements, installation is rejected.
If an older version of openUTM exists on your PC and you decide to install openUTM in the same directory, you will be asked whether you wish to overwrite or uninstall the older version.
If an older version of openUTM exists on your PC and you decide to install openUTM in another directory, the valid version is the one that was most recently installed.