CHANGE-TO-SYSTEM-MODE - Switch to system mode

The CHANGE-TO-SYSTEM-MODE statement causes a switchover to BS2000 system mode. BS2000 commands can subsequently be entered. Provided PAMCONV was not unloaded (e.g. by /START-EXECUTABLE-PROGRAM or /LOAD-EXECUTABLE-PROGRAM), the PAMCONV run can then be continued via /RESUME-PROGRAM.

Format

CHANGE-TO-SYSTEM-MODE                                                                                                                       

     

This statement has no operands.

Alternatively the SYSTEM or SYS statement can be entered to switch to system mode. These statements cannot be further abbreviated.