A UTM dump edited with KDCDUMP normally contains the following information:
KDCROOT with the KDCROOT tables and the DIAGAREAs UTM Diagarea, DB Diagarea, ...).
A summary (Summary information).
A table of contents.
In some cases the dump may contain addition areas which only can be evaluated by the system service and which therefore are not described in this manual (exception: CONS-ENTRIES table). This ares should be provided to the system service if necessary, see section "Producing error documentation".
If the dump was produced due to a PEND ER (either programmed by the user or produced internally after KCRCCC >= 70Z), then the dump only contains the KDCROOT area.To make finding the table easier, the prepared dump contains a list of tables with page numbers at the end of the dump. Each of these prepared tables has a header that identifies the prepared table.
The header starts with the corresponding storage area dumped (e.g. KDCROOT) and the name of the table.
Only those tables are described in the following which you can find in a PENDER dump. In addition, the CONS_ENTRIES table is listed which is created in case of dumps with other reasons and which provides useful information for the user.