The UTM tool KDCUPD outputs both transaction monitor messages and its own messages. With all KDCUPD messages where the text begins with an asterisk (*), it was not possible to transfer the data.
In addition to the messages listed in this section, KDCUPD also outputs messages K184 and K251 to K320, see sections "Messages K147 - K189" and "Messages K191 - K320".
K800 | KDCUPD &VERS started |
K801 | Please enter parameters |
K802 | Control statement KDCFILE: parameter &UPDCMD is not specified |
K803 | Base names of old and new &PARAM17 must be different |
K804 | Transfer from UTM &UPDVERS to UTM &UPDVERS not supported |
K805 | Consistency check for filebase &FBASUPD okay |
K806 | All requested data transferred |
K807 | Requested data partially transferred |
K808 | No data to transfer from &FNAM! |
K809 | Control statement KDCFILE/CHECK: base name &FBASUPD is too longAction: rename file |
K810 | CHECK and KDCFILE commands cannot be combined |
K811 | Control statement KDCFILE: file base must be specified without a cat ID if CATID control statement is used |
K812 | KDCUPD abnormal end |
K813 | KDCUPD normal end |
K814 | &TRANSFER -Transfer of different versions not supported |
K816 | Notice: Database generation changed, open service data will not be transferred |
K851 | &UPDTYP data transferred. KCRN = &UKCRN,&PARAM4 = &UKCLA. |
K852 | &PARAM3 data transferred. KCRN = &UKCRN, &PARAM4 = &UKCLT, KCLA = &UKCLA |
K853 | Database configuration. number: &DBCOUNT FILEOLD: &DBOLD FILENEW: &DBNEWThe configuration of FILEOLD and FILENEW are are inconsistent regarding the configuration of the databases. This message will occur once for every generated database. |
K854 | Warning: Security level of user &USER increased. Password may be invalid. Meaning: The complexity level of the password for the USER &USER is higher in the new KDCFILE than in the old KDCFILE, see USER statement in the KDCDEF generation. If the password transferred does not satisfy this condition, the USER can then no longer sign on. Action: The administrator must then issue a new password. |
K855 | * &UPDTYP data not transferred. KCRN = &UKCRN, &PARAM4 = &UKCLA, KCRCCC = &RCCC, KCRCDC = &RCDC. |
K856 | * &PARAM3 data not transferred. KCRN = &UKCRN, &PARAM4 = &UKCLT, KCLA = &UKCLA, KCRCCC = &RCCC, KCRCDC = &RCDC |
K857 | * Load module &PROG not found. Current version &PVER not transferred. |
K858 | Current version &PVER of load module &PROG transferred. |