Installing ROBAR-CL

The BS2000 component ROBAR-CL is shipped using the SOLIS delivery procedure and installed under any BS2000 user ID using the installation monitor IMON (see the “IMON” manual [6]).

Install ROBAR-CL on all BS2000 systems which are to participate in ROBAR operation.

Configuration of ROBAR-CL is described in the section "Configuring ROBAR-CL".

When upgrading from an earlier ROBAR version, please note the "Notes for ROBAR-CL" in chapter "Upgrading from previous ROBAR versions".

Recommendation if MAREN is being used
Install ROBAR-CL under the same user ID as MAREN ($SYSMAREN).

ROBAR-CL requires a maximum 2 Mbytes of static disk memory and a maximum 4 Mbytes of dynamic disk memory. The size of the dynamic disk memory depends on the trace files saved).

Setting up privileges

If you are using SECOS (see the “SECOS” manual [10]), the installation ID of ROBAR-CL requires the TAPE-ADMINISTRATION privilege (SRPM command /SET-PRIVILEGE PRIV=TAPE-ADMINISTRATION,USER-ID=<name>).

Installation files

The following files are shipped with ROBAR-CL:

SYSPRC.ROBAR-CL.<ver>	Procedure file for starting ROBAR-CL-DCAM
SYSMES.ROBAR-CL.<ver>	Message file
SYSPAR.ROBAR-CL.<ver>.MESSAGES	System messages relevant to ROBAR
SYSPAR.ROBAR-CL.<ver>.PROZPARAM	Parameter file for procedure control
SYSPAR.ROBAR-CL.<ver>.TEXT.D	(for internal use, German)
SYSPAR.ROBAR-CL.<ver>.TEXT.E	(for internal use, English)
SYSPRG.ROBAR-CL.<ver>.DCAM	ROBAR-CL-DCAM application
SYSPRG.ROBAR-CL.<ver>.SDF	ROBAR-CL-SDF user program 1
SYSSDF.ROBAR-CL.<ver>	System syntax file
SYSSII.ROBAR-CL.<ver>	Structural and installation information files for installation with IMON
SYSPRC.ROBAR-CL.<ver>.MAREN	Procedure file for the collection of information from the MAREN catalog
SYSFGM.ROBAR-CL.<ver>.D	Release Notice (German)
SYSFGM.ROBAR-CL.<ver>.E	Release Notice (English)

1	The file SYSPRG.ROBAR-CL.<ver>.SDF is installed by IMON under the standard system ID (system parameter DEFLUID, default: $TSOS).

Further files are created during a system run:

$TSOS.ROBAR.TRACE. <DCAM-name>.<tsn>. <day>-<hour><minute> [.<folgenummer>]	BS2000 trace files created by ROBAR-CL-DCAM. The prefix $TSOS.ROBAR can be modified in the ROBAR start file SYSPRC.ROBAR-CL.<ver> using the TRACE parameter, see "Modifying the start file for ROBAR-CL-DCAM".
SYSRPT.ROBAR-CL.<ver>.<DCAM-Name>.<tsn> or SYSRPT.ROBAR-CL.<ver>.<DCAM-Name>.SYSOUT	SYSOUT output of the ENTER job. The file name is defined in the SYSPRC.ROBAR-CL.<ver> file and can also have a different name. See also "Diagnostic documentation for a BS2000 system".
SYSPAR.ROBAR-CL.<ver>.TEXT	Copy of the internal message texts in German or in English (the language depends on the definitions made in the SYSPRC.ROBAR-CL.<ver> file)