You can perform the following configuration steps in any order before ROBAR-CL is started for the first time.
Editing the message keys for ROBAR-CL
The file SYSPAR.ROBAR-CL.<ver>.MESSAGES contains the message numbers of the BS2000 system messages that are passed to ROBAR-SV (see "File SYSPAR.ROBAR-CL.<ver>.MESSAGES").
You can normally accept the file without modification. If required, you can use an editor (e.g. EDT) to adapt it to the system environment of your data center.
Editing the parameter file
If necessary, adjust the routing code for TYPE commands in the SYSPAR.ROBAR-CL.<ver>.PROZPARAM parameter file (see page "File SYSPAR.ROBAR-CL.<ver>.PROZPARAM").
Otherwise the file can normally be accepted without modifications.
Activating the syntax file
The system syntax file SYSSDF.ROBAR-CL.<ver> contains the system definitions for ROBAR-CL-SDF. It is enabled when installation with IMON takes place or retroactively using the MODIFY-SDF-PARAMETERS command.
Activating the BS2000 message file
The SYSMES.ROBAR-CL.<ver> file contains the messages and help texts for the product ROBAR-CL. The file is activated at the time of installation with IMON or later with the MODIFY-MIP-PARAMETERS or MODIFY-MSG-FILE-ASSIGNMENT command.
Default settings for the console
Set the system option (startup parameter service) NBMSGCSD to Y.
Network entries
The system support must make the necessary entries for the transport system (/BCIN, /BCMAP).