Configuring settings

You can add, change or remove switches to be monitored.

>	Select Hardware -> FC networks, Settings tab. The Settings tab with all information on FC networks opens.

Settings

In the Settings group, you can configure the data update regarding the registered switches (switch discovery) and the therefore necessary access data.
Actions:

>	Enabling/disabling automatic data update ()
>	Updating the FC network data immediately ()
>	Configuring SNMP access data for the automatic discovery of switches ()

Registered Switches

In the Registered Switches group, you can specify which switches are to be registered in SEM.
Actions:

>	To add a switch to the list of registered switches, click Add switch. In the Add switch wizard, you can make the required entries step by step.
>	To automatically discover and register further switches of the respective fabric for switches that have already been registered, select one or more switches in the table and click Add fabric switches. The Add fabric switches wizard enquires the fabric switches and adds them to the list of registered switches.
>	To automatically discover and register further virtual switches of the respective physical switch in addition to already registered switches, select one or more switches in the table and click Add virtual switches. The Add virtual switches wizard enquires the fabric switches and adds them to the list of registered switches.
>	To view additional information about the registered switches, click the Show more columns () icon. The following additional information is then displayed: Comment and the properties: model, OS version, available ports and hardware ports. Clicking the icon again hides the additional table columns again.
>	To change the check status of the switches, select one or more switches in the table and click the Change check status of selected switches () icon. You can activate or deactivate the check.
>	To remove switches from the list of registered switches, select one or more switches in the table and click the Remove selected switches () icon.
>	To change the settings for a switch, click the Change () icon at the desired switch in the table, follow the instructions of the following wizard, and confirm your changes.